I've had no problems with fuses till now. I'd rather have working lights than no lights. I didn't know this till I did it again today. When I "fixed" my problem, the amp wasn't connected at the time. Well, last week when I "fixed" my problem, I did the same thing. Figured I'd just turn it to acc each time that way the amp isn't running. I disconnected my amp mainly because I didn't want to have to start and shut off the car each time I went to test the fuse. ![]() Started up my car, no clusters lights, or parking lights.Įdit: Well it turns out to be my amplifier that is causing the parking lamp fuse to blow. Well sad to say the problem decided to rear is ugly head this morning. 3057 is for the rear tail parking/turn signal/breaking lamp. 3157 is the front parking/turn signal lamp. Moral of this story, don't buy your light bulbs at Walmart. Good thing I did this because everything works now. So, I took out both driver and passenger side tail light bulbs and put in a set of Silverstar bulbs I bought the same day I bought the replacement set. My dad said it could have been a bad set of bulbs I bought. So my only though was the bulb themselves. It did need a good cleaning though so i did that. License plate bulb is also good as well as the harness. I'm assuming the bulbs for the sedan tail lights vs coupe are different? I check the good bulb on the driver side and it was a 3057.Īfter tearing my trunk apart looking for shorts or bad wiring i found none. I check around the net because I was getting two different sizes, 31.Ĭar Replacement Light Bulb Size Guide – 2005 Chevrolet Cobalt He must have seen my tail lights out but never nailed me cause my working place was 10 feet down the road. A cop was sitting at the intersection to where I pull into my work place the day I notice my dash lights where out. I really need to get this fixed today as I do go to work early in the morning while it's still dark out. Might have went but I've never had an led burn out on me. The bulb is an led that I put in 2 days after I bought the car which was over 2 years ago. I did read on this forum that the wires do go bad because of exposure to the elements. I will be checking the license plate bulb and wiring today. Check for a bad connection in the wires to the tails in which I saw nothing Three times I tried replacing the fuse and all three times it blew. So today I replaced the fuse however with another 15a fuse, started up the car, nothing. I found this to be quite odd being that the only thing I did was replace a tail light bulb. So I started looking at fuses and found out that the parking lamp fuse blew. My brake lights worked however, just not the parking lights.Īfter getting home I did some research and found out that this problem indicates that my tail lights aren't working. Thursday morning I started up my car to head to work I noticed I had no dash lights except for my stereo which was the only thing working. So I got a replacement bulb (3057) put it in, everything back to normal. I got to the mall, had my brother check the lights and he said the passenger side tail was out. ![]() I figured this was indicating a burnt out bulb somewhere. ![]() If you find that the information is wrong or you need to add something, please feel free to contact us, we are grateful for any customer's opinion.ĭidn't find your vehicle? Use the bulb finder system to get the bulb size.This past Tuesday on my way to the mall, I noticed my right turn signal indicator was blinking really fast. However, the information in the table is not 100% correct due to manufacturer-specific reasons. Chevrolet Cobalt (2005-2010) Bulb Size Chart If you notice any inaccuracies or missing information, please let us know so we can promptly update the guide. Aftermarket headlights, Fog Lights, tail lights, etc., may have different bulb sizes as per the manufacturer's specifications.Īccuracy and completeness are vital to us and our followers. Note: This guide is only for 2005-2010 Chevrolet Cobalt models with original factory (OEM) assemblies. Didn't find your vehicle? Use the bulb finder system to get the bulb size.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |